Mitsubishi Electric M700VS Series Setup Manual page 243

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1062】 T_cmp Tool compensation function
Select whether the tool length compensation and wear compensation are enabled during T
command execution.
0 : Tool length compensation enable
1 : Tool length compensation enable
2 : Tool length compensation disable
3 : Tool length compensation disable
【#1063】 mandog Manual dog-type
Select the manual reference position return method for the second return (after the coordinate
system is established) and later.
The initial reference position return after the power ON is performed with dog-type return, and the
coordinate system will be established.
(This setting is not required when the absolute position detection is used.)
0: High speed return
1: Dog-type
【#1064(PR)】 svof Error correction
Select whether to correct the error when the servo is OFF.
0: Not correct the error
1: Correct the error
【#1068(PR)】 slavno Secondary axis number
Set the axis number of the secondary axis in synchronous control.
The axis number is an NC number excluding the spindle and PLC axis.
Two or more secondary axes cannot be set for one primary axis.
This parameter cannot be set for a secondary axis.
When using the multi-part system, the relation of the primary axis and secondary axis cannot extend
over part systems.
0: No secondary axis
1 to 16: First to sixteenth axis
【#1069】 no_dsp Axis with no counter display
Select whether to display the axis counter or not.
This setting is enabled on the counter display screen (relative position counter, etc.).
0: Display
1: Not display
【#1070】 axoff Axis removal
Select whether to enable or disable axis removal control.
0: Disable
1: Enable
【#1072】 chop_ax Chopping axis
Select the chopping axis.
0: Non-chopping axis
1: Chopping axis
【#1073】 I_Absm Initial absolute setting
Select the mode (absolute or incremental) at turning ON the power or reset.
0: Incremental setting
1: Absolute setting
【#1074】 l_Sync Initial synchronous feed
Select the feedrate mode at turning ON the power or reset.
0: Asynchronous feed (feed per minute)
1: Synchronous feed (feed per revolution)
【#1075】 I_G00 Initial G00
Select the linear command mode at turning ON the power or reset.
0: Linear interpolation (G01 command state)
1: Positioning (G00 command state)
226
Wear compensation enable
Wear compensation disable
Wear compensation enable
Wear compensation disable