Mitsubishi Electric M700VS Series Setup Manual page 173

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#8017】 G71 DELTA-D (for L system only)
Set the change amount of the rough cutting cycle.
The rough cutting cycle (G71, G72) cutting amount repeats d+ ⊿ d, d, d- ⊿ d using the value (d)
commanded with D as a reference. Set the change amount ⊿ d.
---Setting range---
0 to 999.999 (mm)
【#8018】 G84/G74 n (for M system only)
Not used. Set to "0".
【#8019】 R COMP
Set a compensation coefficient for reducing a control error in the reduction of a corner roundness
and arc radius.
The larger the set value is, the smaller the theoretical error will be. However, since the speed at the
corner goes down, the cycle time will be extended.
Coefficient = 100 - set value
(Note) This function will be enabled when "#8021 COMP_CHANGE" is set to "0".
---Setting range---
0 to 99 (%)
Theoretical radius decrease error amount
Displays the theoretical radius decrease error amount, ΔR(mm), from the automatic calculation by
NC.
Path after
servo control
Theoretical radius decrease amount in arc
R5mm arc deceleration speed
Displays a deceleration speed(mm/min) along an arc of 5(mm) radius.
R1mm arc deceleration speed
Displays a deceleration speed(mm/min) along an arc of 1(mm) radius.
156
Command path
R
F
+