Mitsubishi Electric M700VS Series Setup Manual page 196

【#8918】 Auto backup day 4
When the NC power is ON after the designated date was passed over, the automatic backup is
executed.
When "-1" is set to "Auto backup day 1", the automatic backup is executed every turning NC power
ON.
When "0" is set to all on "Auto backup day 1" to "4", the automatic backup is not executed.
It is possible to specify the designated date up to 4 days for a month.
---Setting range---
-1 to 31("-1" can be set for "Auto backup day 1" only.)
【#8919】 Auto backup device
Select the automatic backup target device.
[M700/M700VW Series]
0: DS
1: HD
2: Memory card
[M700VS/M70V Series]
0: Memory card
3: USB memory
[M70 Series]
0: Memory card
(Note) The setting range differs according to the model.
【#8920】 3D tool ofs select
Select the method to calculate the drawing position when drawing a solid.
With 3D drawing, the drawing position (tool tip position) is calculated with the method designated
with this parameter, and the image is drawn.
0: For tool radius compensation, use the tool compensation amount set in tool compensation
1: Use the tool compensation amount set in tool compensation screen for both tool radius and tool
2: Use the value set in tool set window for both tool radius and tool length compensation. (for tool
3: Use the value set in tool set window for both tool radius and tool length compensation. (for tool
【#8921】 Mass Edit select
Select the editing mode for the machining programs saved in HD, FD, and memory card.
When the program size is 1.0MB (When "#8910 Edit Undo" is invalid, 2.0MB) or more, mass-editing
will be applied.
0: Regular editing mode
1: Mass-editing mode
【#8922】 T-reg-dup check
Set whether to enable the duplication check in registering tools to magazine pots, and in setting tool
Nos. for spindle/standby.
0: Duplication check valid for all valid magazines
1: Duplication check invalid
2: Duplication check valid only for the selected magazine
【#8923(PR)】 Hide Edit-IO menu
Set whether to enable the edit-in/out menu. When disabled, the edit-input/output menu won't appear.
However, the maintenance-in/out menu is always enabled regardless of this parameter setting.
0: Enable
1: Disable
【#8924】 MEAS. CONFIRM MSG
Select whether to display a confirming message when attempting to write compensation data for tool
measurement, or coordinate system data for workpiece measurement.
0: Not display a confirming message
1: Display a confirming message
screen. For tool length, use the value in tool set window. (for tool length measurement type I)
length compensation. (for tool length measurement type II)
length measurement type I)
length measurement type II)
M700VS Series Setup Manual
Appendix 1.1 User Parameters
179