Mitsubishi Electric M700VS Series Setup Manual page 309

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#2007】 G1tL G1 time constant (linear)
Set a linear control time constant for cutting acceleration and deceleration.
The time constant will be enabled when LC (cutting feed with linear acceleration/deceleration) or F
(soft acceleration/deceleration) is selected in "#2003 smgst Acceleration or deceleration modes".
Speed
---Setting range---
1 to 4000 (ms)
【#2008】 G1t1 G1 time constant (primary delay)/Second-step time constant for soft
acceleration/deceleration
Set the primary delay time constant for cutting acceleration and deceleration.
The time constant will be enabled when C1 (cutting feed with the primary delay) or C3 (cutting feed
with exponential acceleration and linear deceleration) is selected in "#2003 smgst acceleration/
deceleration modes".
When the soft acceleration or deceleration is selected, the second-step time constant will be used.
<Cutting feed with primary delay>
Speed
<Cutting feed with exponential acceleration and linear deceleration>
Speed
<Soft acceleration/deceleration>
Speed
---Setting range---
1 to 5000 (ms)
【#2009】 G1t2
Not used. Set to "0".
292
G1tL G1tL
G1t1 G1t1
2 x G1t1
G1t1
G1t1 G1t1
G1t1
G1t1
G1tL
G1tL
Time
Time
Time
Time