Mitsubishi Electric M700VS Series Setup Manual page 182

【#8123】 H-spd retract ON
Select whether to enable the drilling cycle at high-speed retract in fixed cycle for drilling.
0: Disable
1: Enable
【#8124】 Mirr img at reset
Select the operation type of the mirror image by parameter setting and the mirror image by external
input.
0: The current mirror image is canceled, and new mirror image will start with the machine position
1: The mirror center is kept to continue the mirror image.
【#8125】 Check Scode in G84
Select how to operate when there is no S command in synchronous tapping block.
0: Use the spindle function modal value as S-command value.
1: Output a program error.
【#8126】 Disable op tone
Select whether to disable keyboard/touch panel operation tones.
0: Enable the operation tones
1: Disable the operation tones
(Note)This setting is valid only for M700VS/M70V/M70 Series.
【#8145】 Validate F1 digit
Select whether to execute the F command with a 1-digit code command or with a direct numerical
command.
0: Direct numerical command (command feedrate during feed per minute or rotation)
1: 1-digit code command (with the feedrate specified by the parameters "#1185 spd_F1" to "#1189
【#8154(PR)】
Not used. Set to "0".
【#8155】 Sub-pro interrupt
Select the method for the user macro interrupt.
0: The user macro interrupt of macro type
1: The user macro interrupt of sub-program type
【#8156】 Fine thread cut E
Select the address E type when cutting an inch screw.
0: Specify the number of threads per inch for inch screw cutting.
1: Specify the precision lead for inch screw cutting.
【#8157】 Radius comp type B (M system) / Nose R comp type B (L system)
For M system
Select the method of the arithmetic processing for the intersection point when the start-up or cancel
commands are operated during radius compensation.
0: The processing does not handle the start-up or cancel command block: handle the offset vector
1: The processing is executed for the intersection point between the command block and the next
For L system
Select the method of the arithmetic processing for the intersection point when the start-up or cancel
commands are operated during nose R or radius compensation.
0: The processing does not handle the start-up or cancel command block: handle the offset vector
1: The processing is executed for the intersection point between the command block and the next
at reset as the mirror center.
spd_F5")
in the direction vertical to that of the command instead.
block.
in the direction vertical to that of the command instead.
block.
M700VS Series Setup Manual
Appendix 1.1 User Parameters
165