Mitsubishi Electric M700VS Series Setup Manual page 67

MITSUBISHI CNC
4 Setting the Parameters and Date/Time
(3) Carry out the spindle and servo axis settings. Set the following items.
Common setting
Number of spindles: Set the number of spindles connected to the NC. This setting is registered at "#1039
spinno (Number of spindles)".
Setting by system
Number of axes:
Command type
Setting by spindle area
Ch / Rotary SW No.
Motor type:
Power Supply type:
Setting by servo
Ch / Rotary SW No.
Motor type:
Detector type:
Power Supply type:
50
Set the number of axes for each part system and PLC. This setting is registered at "#1002
axisno (Number of axes)".
(Note) A setting error occurs if a value "1" or higher is set for any of the 2nd to 4th part
systems while the setting for the previous part system is "0".
Set the command type for each part system. This setting is registered at "#1037 cmdtyp
(Command type)".
(Note) Although this can be set individually for each part system, it will be shared by
the entire part system if specified for the machining center.
Set the servo I/F connection channel and the rotary switch No. (2-digit value) for each spindle
drive unit. This setting is registered at "#3031 smcp_no (Drive unit I/F channel No. (spindle))".
1st digit: Servo I/F connection channel
2nd digit: Rotary switch No.
Set the motor types that are connected to each spindle. Input the values as indicated at the
guidance display area. The input values are not converted to motor types.
Set the power supply types that are connected to each spindle drive unit.
Input the values as indicated at the guidance display area. The input values are then converted
to, and displayed as, power supply types. "0" means "No connection".
Set the servo I/F connection channel and the rotary switch No. (2-digit value) for each servo
drive unit. This setting is registered at "#1021 mcp_no (Drive unit I/F channel No. (servo))".
1st digit: Servo I/F connection channel
2nd digit: Rotary switch No.
Set the motor types that are connected to each servo axis.
Input the values as indicated at the guidance display area. The input values are then converted
to, and displayed as, motor types.
Set the encoder types that are connected to each servomotor.
Input the values as indicated at the guidance display area. The input values are then converted
to, and displayed as, encoder types.
Set the power supply types that are connected to each servo drive unit.
Input the values as indicated at the guidance display area. The input values are then converted
to, and displayed as, power supply types. "0" means "No connection".