Mitsubishi Electric M700VS Series Setup Manual page 292

【#1512】 DOORPs Signal input device 2 for door interlock II: for each part system
Set the fixed device number (X??) for door interlock II signal input for each part system.
(Set the same value as that of #1155.)
Related parameter: "#1154 pdoor (Door interlock II for each part system)"
---Setting range---
000 to 2FF (hexadecimal)
【#1513】 stapM M code for synchronous tap selection
Set the M code for the synchronous tapping selection.
Select the synchronous tapping mode using the miscellaneous function code of the value set in this
parameter. The M function command can be issued immediately before the tap command or in the
same block. This function is valid only when "1" is set in "#1272 ext08/bit1 (Enable/disable M-
function synchronous tap cycle)".
(Note) Do not use M00, 01 02, 30, 98, and 99.
---Setting range---
0 to 99999999
【#1514】 expLinax Exponential function interpolation linear axis
Set the axis name for the linear axis used in exponential function interpolation.
---Setting range---
A to Z
【#1515】 expRotax Exponential function interpolation rotary axis
Set the axis name for the rotary axis used in exponential function interpolation.
---Setting range---
A to Z
【#1516】 mill_ax Milling axis name
Set the name of the rotary axis used in milling interpolation. Only one rotary axis can be set.
When there is no E command in issuing the G12.1 command, this parameter will be followed.
---Setting range---
A to Z
【#1517】 mill_C Milling interpolation hypothetical axis name
Select the hypothetical axis command name for milling interpolation.
When there is no D command in issuing the milling interpolation command, this parameter will be
followed.
0: Y axis command
1: Command rotary axis name.
【#1518】 polm Spindle-spindle polygon Workpiece spindle No.
Set the workpiece axis No. used in spindle-spindle polygon machining.
(Note) The 1st spindle will be selected when "0" is set.
【#1519】 pols Spindle-spindle polygonTool spndle No.
Set the number of the rotary tool spindle used in spindle-spindle polygon machining.
(Note) The 2nd spindle will be selected when "0" is set.
【#1520(PR)】 Tchg34 Additional axis tool compensation operation (for L system only)
Select axis to carry out the additional axis' tool compensation function.
0: 3rd axis.
1: 4th axis.
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
275