Mitsubishi Electric M700VS Series Setup Manual page 291

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1495(PR)】 grf_ax_direction Axis travel direction in 2D graphic
Select the axis travel direction in the 2D graphic drawing (trace, check).
If set to 1, the positive/negative directions are reversed.
---Setting range---
0/1
【#1501】 polyax Rotational tool axis number (for L system only)
Set the number of the rotational tool axis used for polygon machining (G51.2). Set "0" when not
using polygon machining (spindle-servo axis), or when using spindle-spindle polygon machining. A
value exceeding the base specification parameter "#1002 axisno" cannot be specified.
This parameter is valid when the G code system is 6 or 7 (7 or 8 is set in base specification
parameter "#1037 cmdtyp").
【#1502】 G0Ipfg G1 -> G0 deceleration check
Select whether to perform a deceleration check when the travel direction is changed from G1 to G0.
0: Not perform
1: Perform
【#1503】 G1Ipfg G1 -> G1 deceleration check
Select whether to perform a deceleration check when the travel direction is changed from G1 to G1.
0: Not perform
1: Perform
【#1505】 ckref2 Second reference position return check
Select whether the check is carried out at the specified position in manual second reference position
return mode upon completion of spindle orientation or at second reference position return interlock
signal.
0: Upon completion of spindle orientation
1: At second reference position return interlock signal
【#1506】 F1_FM Upper limit of F1-digit feedrate
Set the maximum value up to which the F 1-digit feedrate can be changed.
---Setting range---
0 to 1000000 (mm/min)
【#1507】 F1_K F 1-digit feedrate change constant
Set the constant that determines the speed change rate per manual handle graduation in F 1-digit
feedrate change mode.
---Setting range---
0 to 32767
【#1510】 DOOR_H Shorten door interlock II axis stop time
Select whether to shorten the time during which the axis is stopped when the door is opened.
0 : Use the conventional axis stop time.
1 : Shorten the axis stop time.
(Note) When the door interlock II signal is input via a ladder, the conventional axis stop time will be
【#1511】 DOORPm Signal input device 1 for door interlock II: for each part system
Set the fixed device number (X??) for door interlock II signal input for each part system.
A device number from X01 to XFF can be specified.(Except X100.)
Device number "000" is invalid.
Set device number "100" when using no fixed device number for door interlock II signal input.
Related parameter: "#1154 pdoor (Door interlock II for each part system) "
---Setting range---
000 to 2FF (hexadecimal)
274
used.