Mitsubishi Electric M700VS Series Setup Manual page 528

M01 APLC password mismatch 0280
Details
The APLC authentication password is inconsistent.
Remedy
- Contact the machine tool builder.
M01 Illegal movement command during superimposition 1003
Details
- A machine command was issued to the superimposing axis.
- Reference position return was attempted on the superimposing axis.
- Skip command was issued to the master or superimposing axis.
- Dog-type reference position return was attempted on the master axis.
Remedy
- Correct the program.
M01 Superimposition command illegal 1004
Details
- Superimposition command (G126) was issued to the axis which is executing the following functions.
Synchronization control
Milling interpolation
- Superimposition start command was issued to the axis which was under superimposition control.
- The superimposition command was issued to an axis that belongs to the same part system as a
basic or synchronous axis of synchronization across part systems.
Remedy
- Correct the program.
M01 G114.n command illegal 1005
Details
G114.n has been commanded during the execution of G114.n.
G51.2 has been commanded when G51.2 spindle-spindle polygon machining mode has been already
entered at another part system.
Remedy
- Command G113 to cancel the operation.
- Turn ON the "spindle synchronization cancel" signal to cancel the operation.
- Command G50.2 to cancel the operation.
- Turn ON the "spindle-spindle polygon cancel" signal to cancel the operation.
M01 Spindle in-use by synchro tap 1007
Details
The spindle is being used in synchronized tapping.
Remedy
- Cancel the synchronized tapping.
M01 SP-C ax ctrl runs independntly 1026
Details
C axis mode command has been issued for polygon machining spindle.
C axis mode command has been issued for synchronized tapping spindle.
Polygon command has been issued for synchronized tapping spindle.
Spindle is being used as spindle/C axis.
Remedy
- Cancel the C axis command.
- Cancel the polygon machining command.
- Cancel the C axis with servo OFF.
M700VS Series Setup Manual
Appendix 2.1 Operation Errors (M)
511