Mitsubishi Electric M700VS Series Setup Manual page 499

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#12912】 aux_pusht2 Stopper torque release time
Set the time from the completion of the stopper operation to the changeover of the stopper torque in
the stopper positioning.
---Setting range---
0 to 9999(ms)
【#12913】 aux_pusht3 Set position signal output delay time
Set the time from the completion of the stopper operation to the output of the "automatic set position
reached" (JSTA), "set position reached" (JST) or "near set position" (NEAR) signal in the stopper
positioning.
---Setting range---
0 to 9999(ms)
482