Mitsubishi Electric M700VS Series Setup Manual page 323

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#2098】 tlml2+ Sub side tool setter + direction sensor
Set the sensor position (on sub side) in (+) direction when using the tool setter on the sub spindle
side.
(Note) In the case of the basic axis and inclined axis of the inclined axis specifications, set the
---Setting range---
-99999.999 to 99999.999 (mm)
【#2102】 skip_tL Skip time constant linear
Set a linear control time constant for variable speed skip acceleration and deceleration, or for an
occasion where a skip command issues acceleration/deceleration time constant enabled (R1).
The time constant will be enabled when LC (cutting feed with linear acceleration and deceleration) or
"F" (soft acceleration/deceleration) is selected in "#2003 smgst Acceleration and deceleration
modes".
When set to "0", the time constant set by "#2008 G1t1" is used.
---Setting range---
0 to 4000 (ms)
【#2103】 skip_t1 Skip time constant primary delay / Second-step time constant for soft
acceleration/deceleration
Set a primary-delay time constant for variable speed skip acceleration and deceleration, or for an
occasion where a skip command issues acceleration/deceleration time constant enabled (R1).
The time constant will be enabled when C1 (cutting feed with primary delay) or C3 (exponential
acceleration and linear deceleration) is selected in "#2003 smgst Acceleration and deceleration
modes". When the soft acceleration/deceleration is selected, the second-step time constant will be
used.
When set to "0", the time constant set by "#2008 G1t1" is used.
---Setting range---
0 to 5000 (ms)
【#2106】 Index unit Indexing unit
Set the indexing unit to which the rotary axis can be positioned.
---Setting range---
0 to 360 (°)
【#2109】 Rapid (H-precision) Rapid traverse rate for high-accuracy control mode
Set the rapid traverse rate for each axis in the high-accuracy control mode. "#2001 rapid" will be
used when "0" is set.
---Setting range---
0 to 1000000 (mm/min)
【#2110】 Clamp (H-precision) Cutting feed clamp speed for high-accuracy control mode
Set the cutting feed maximum speed for each axis in the high-accuracy control mode. "#2002 clamp"
will be used when "0" is set.
---Setting range---
0 to 1000000 (mm/min)
【#2111】 Blf valid Quadrant protrusion compensation valid
Set whether to enable the quadrant protrusion compensation.
0: Disable
1: Enable
If either of "#2112 Blf motor inertia", "#2115 Blf motor stl trq" or "#2113 Blf visc friction" is set to "0",
quadrant protrusion compensation will not work even if this parameter is set to "1".
306
position on the orthogonal coordinate.