Mitsubishi Electric M700VS Series Setup Manual page 185

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#8213(PR)】 Rotation axis type
Select the rotation type (short-cut valid/invalid) or linear type (workpiece coordinate linear type/all
coordinate linear type).
This parameter is enabled only when "#1017 rot" is set to "1". (Note)
0: Short-cut invalid
1: Short-cut valid
2: Workpiece coordinate linear type
3: All coordinate linear type
(Note) The movement method is as follows by the specified rotation axis type.
<Workpiece coordinate value>
<Machine coordinate value/relative position>
<ABS command>
<INC command>
<Reference position return>
【#8215】 TLM std length
Set the TLM standard length.
TLM standard length is the distance from a tool replacement point (reference position) to the
measurement basic point (surface) which is used to measure the tool length.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8216】 Type in G28 return
Select the performance after establishing the reference position in reference position return
command.
0: Moves to the reference position.
1: Won't move to the reference position.
【#8217】 Check start point
Set a drawing start position in graphic check of each axis.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8300】 P0 (for L system only)
Set the reference X-coordinates of the chuck and the tail stock barrier.
Set the center coordinate (radius value) of workpiece by the basic machine coordinate system.
---Setting range---
-99999.999 to 99999.999 (mm)
168
0,1 : Display range 0° to 359.999°
2,3 : Display range 0° to ±99999.999°
0,1,2 : Display range 0° to 359.999°
3 : Display range 0° to ±99999.999°
0 : The incremental amount from the end point to the current position is divided by 360, and the
axis moves by the remainder amount according to the sign.
1 : Moves with a short-cut to the end point.
2,3 : In the same manner as the normal linear axis, moves according to the sign by the amount
obtained by subtracting the current position from the end point.
0,1,2,3 : Moves in the direction of the commanded sign by the commanded incremental
amount starting at the current position.
0,1,2 : The movement to the middle point applies to the ABS command or the INC command.
Returns with movement within 360 degrees from the middle point to reference position.
3 : The movement to the middle point applies to the ABS command or the INC command.
Moves and returns in the reference position direction for the difference from the current
position to the reference position.