Mitsubishi Electric M700VS Series Setup Manual page 256

【#1200(PR)】 G0_acc Validate acceleration and deceleration with inclination angle constant
G0
Select the acceleration and deceleration type when a rapid traverse command is issued.
0: Acceleration and deceleration with constant time (conventional type)
1: Acceleration and deceleration with a constant angle of inclination
(Note) When rapid traverse constant inclination multi-step acceleration/deceleration is valid, this
【#1201(PR)】 G1_acc Validate acceleration and deceleration with inclination constant G1
Select the acceleration and deceleration type when a linear interpolation command is issued.
0: Acceleration and deceleration with constant time (conventional type)
1: Acceleration and deceleration with a constant angle of inclination
【#1202】 mirofs Distance between facing turrets (for L system only)
Set the distance between tools (edges) (between facing turrets).
---Setting range---
0 to 99999.999 (mm)
【#1203】 TmirS1 Select turrets as facing turrets with T command (for L system only)
Select the turrets, which correspond to the tool Nos. 1 to 32, as facing turrets for T code mirror
image.
---Setting range---
0 to FFFFFFFF
【#1204】 TmirS2 Select turrets as facing turrets with T command (for L system only)
Select the turrets, which correspond to the tool Nos. 33 to 64, as facing turrets for T code mirror
image.
---Setting range---
0 to FFFFFFFF
【#1205】 G0bdcc Acceleration and deceleration before G0 interpolation
0: Post-interpolation acceleration/deceleration is applied to G00.
1: Pre-interpolation acceleration/deceleration is applied to G00 even in the high accuracy control
2: Rapid traverse constant inclination multi-step acceleration/deceleration is enabled.
(Note) "1" cannot be set for the 2nd part system and the following.
【#1206】 G1bF Maximum speed
Set a cutting feedrate when applying pre-interpolation acceleration/deceleration.
When high-accuracy control time constant expansion is valid, set the maximum of cutting feed clamp
speed of each axis.
---Setting range---
1 to 999999 (mm/min)
parameter will be invalid.
mode.
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
239