Mitsubishi Electric M700VS Series Setup Manual page 272

【#1240(PR)】 set12
bit0: Handle input pulse
Select the handle input pulse.
0: MITSUBISHI CNC standard handle pulse (25 pulse/rev)
1: Handle 400 pulse (100 pulse/rev)
bit2: Zero point shift amount magnification
When "1" is set, the following magnification will be applied on the "#2027 G28sft Reference position
shift distance", "#2057 Near zero point +" and "#2058 Near zero point -" settings.
For 0.1μm: 10-fold
For 0.01μm: 100-fold
bit4: Optical communication automatic channel detection invalid
Select whether to enable the optical communication automatic channel detection.
0: Enable
1: Disable
【#1241(PR)】 set13
bit0 : No G-CODE COMB. Error
Select the operation for when an illegal combination of modal and unmodal G codes are
commanded in a same block.
0：The program error (P45) will occur.
1：A program error can be avoided but the modal G code will be ignored.
【#1242】 set14
Not used. Set to "0".
【#1243】 set15
Not used. Set to "0".
【#1244】 set16
Not used. Set to "0".
【#1245】 set17
bit7: Synchronous tap spindle rotation direction type
Select whether the spindle's rotation direction is determined by the synchronous tapping axis' travel
direction.
0: The spindle's rotation direction is determined by the synchronous tapping axis' travel direction.
1: The spindle always rotates forward regardless of the synchronous tapping axis' travel direction.
(Note)When a reverse tap is commanded, the spindle rotates in an opposite direction to that
When the travel direction is negative, the spindle rotates forward.
When the travel direction is positive, the spindle rotates in reverse.
mentioned above.
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
255