Mitsubishi Electric M700VS Series Setup Manual page 244

【#1076】 Abslnc ABS/INC address (for L system only)
Select the command method for the absolute and incremental commands.
0: Use G command for the absolute and incremental commands.
1: Use axis name for the absolute and incremental commands.
(The axis name in "#1013 axname" will be the absolute command, "#1014 incax" will be the
When "1" is selected, using two axis names, one each for the absolute and incremental commands,
allows to issue the absolute and incremental commands appropriately to an axis.
【#1077】 radius Incremental command for diameter specification axis
Select whether the incremental command of the diameter specification axis ("#1019 dia" is set to "1")
uses the diameter value or radius value.
0: Diameter value
1: Radius value
【#1078】 Decpt2 Decimal point type 2
Select the increment of position commands that do not have a decimal point.
0: Minimum input command unit (follows "#1015 cunit")
1: 1mm (or 1inch) unit (For the dwell time, 1s unit is used.)
【#1079】 F1digt Validate F1 digit
Select the F command method.
0: Direct numerical command (command feedrate during feed per minute or rotation)
1: 1-digit code command (feedrate set with "#1185 spd_F1" to "#1189 spd_F5")
【#1080】 Dril_Z Specify boring axis (for M system only)
Select a fixed cycle hole drilling axis.
0: Use an axis vertical to the selected plane as hole drilling axis.
1: Use the Z axis as the hole drilling axis regardless of the selected plane.
【#1081】 Gmac_P Give priority to G code parameter
Select the G code priority relationship during the macro call with G command.
0: Priority is on G code used in the system
1: Priority is on registered G code for call
【#1082】 Geomet Geometric
Select the type of geometric to use.
0: Not use
1: Use only geometric I
2: Use geometric I and IB
With geometric, specific address codes are used for exclusive meanings. Thus, if A or C is used for
the axis name or 2nd miscellaneous command code, the A used for the axis name may function as
the geometric's angle designation. Pay special attention to axis names, etc., when using this
function.
【#1084】 RadErr Arc error
Set the tolerable error range when the end point deviates from the center coordinate in the circular
command.
---Setting range---
0 to 1.000 (mm)
【#1085】 G00Drn G00 dry run
Select whether to apply dry run (feed at manual setting speed instead of command feedrate) to the
G00 command.
0: Not apply to G00. (move at rapid traverse rate)
1: Apply to G00. (move at manual setting speed)
incremental command.)
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
227