Mitsubishi Electric M700VS Series Setup Manual page 294

【#1538】 crsax[2]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where
the mixed control (cross axis control) request signal is input, or the name of the axis to be shifted to
that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1539】 crsax[3]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where
the mixed control (cross axis control) request signal is input, or the name of the axis to be shifted to
that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1540】 crsax[4]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where
the mixed control (cross axis control) request signal is input, or the name of the axis to be shifted to
that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1541】 crsax[5]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where
the mixed control (cross axis control) request signal is input, or the name of the axis to be shifted to
that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1542】 crsax[6]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where
the mixed control (cross axis control) request signal is input, or the name of the axis to be shifted to
that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1543】 crsax[7]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system where
the mixed control (cross axis control) request signal is input, or the name of the axis to be shifted to
that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
M700VS Series Setup Manual
Appendix 1.2 Base Specifications Parameters
277