Mitsubishi Electric M700VS Series Setup Manual page 157

MITSUBISHI CNC
12 Hardware Replacement Methods
(5) After touching ten points, the display will show the result.
When the result shows "OK":
The calibration settings have been successfully measured.
Turn the right rotary switch (RSW2) back to "0", then turn the power ON again.
When the result shows "NG":
Press the leftmost menu key
If "NG" still shows after reconfirmations, carry out the calibration again from the step (1).
(Note) Pressing the rightmost menu key
screen. When the screen appears, turn the right rotary switch (RSW2) back to "0" and turn the power ON
again.
140
<Result: OK>
and carry out the confirmation again.
<Result: NG>
Points which has resulted
in NG will be shown in red.
after the result has showed "OK" displays the maintenance