Mitsubishi Electric M700VS Series Setup Manual page 481

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#10955(PR)】 Condition kind 3
Set the condition (alarm or PLC signal) for the automatic notification of alarms.
Set the alarm type for alarm, device (register) name for PLC signal.
<Alarm>
Operation alarm (Mxx)
Stop code (Txx)
Servo alarm (Sxx)
Spindle servo alarm (Sxx)
System alarm (Zxx)
Absolute position detection alarm (Zxx)
Emergency stop (EMG)
Auxiliary axis servo alarm (Sxx)
Auxiliary axis absolute position detection alarm (Zxx)
Auxiliary axis OP error (Mxx)
Auxiliary axis MCP alarm (Yxx)
Computer link error (Lxx)
Operation error (Exx)
User PLC alarm (PLxx)
<Device (resister)>
1-bit data ... X,Y,U,W
16-bit data ... R
(Note) Set "0" to cancel (set blank for) any setting of #10951 to #10970, "Condition kind" 1 to 10 and
---Setting range---
Within 5 characters
【#10956(PR)】 Condition num 3
Set the condition (alarm or PLC signal) for the automatic notification of alarms.
Set the alarm No. for alarm, status value for PLC signal.
(Note) Set "0" to cancel (set blank for) any setting of #10951 to #10970, "Condition kind" 1 to 10 and
---Setting range---
Within 4 characters
464
"Condition num" 1 to 10.Input "00" to set "Condition num" to "0".When either of "Condition kind"
or "Condition num" is canceled, the condition will not be available for the automatic notification
of alarms.
"Condition num" 1 to 10.Input "00" to set "Condition num" to "0".When either of "Condition kind"
or "Condition num" is canceled, the condition will not be available for the automatic notification
of alarms.