SeeMeCNC Rostock MAX v2 Assembly Manual page 9

•
PermaTex Ultra Copper High Temp RTV
•
A small razor knife like an X-Acto knife. This will be handy for cleaning the flashing off the
injection molded parts.
•
1/2" wide roll of Kapton tape
•
A digital caliper. These can be purchased from Harbor Freight tools for around $10.
•
A small squeeze clamp that can open at least 6"
•
Battery powered screwdriver. If you ever needed an excuse to buy one of these, THIS IS IT.
•
Pencil.
•
40W Soldering Iron.
•
Blue thread locking compound (Loctite or Permatex Threadlocker Blue)
•
A small file.
•
Elmer's Glue Stick – must be marked "Disappearing Purple".
•
Toothpicks
•
Isopropyl Alcohol
•
12" framing square.
•
1 Roll of ABS filament. Needed to print the fan shrouds at the end of the build.
Rostock MAX v2 Assembly Guide
9