SeeMeCNC Rostock MAX v2 Assembly Manual page 293

some cases can cause the slicing operation to fail. The Repair option is MatterSlice's attempt to help
fix these issues if they're detected.
On the Output Options page is a single parameter, Center On Bed. This will automatically
center the model on the print bed when you load it. If you don't want that to happen, just uncheck the
box.
The Multiple Extruders page has two settings that control how ooze & filament wipes are
handled.
The Wipe Shield Distance specifies how far away from the part you want what is commonly
known as an "ooze shield" to be placed around the part. In a two extruder system, the unselected hot
end will create this "shield" in order to avoid dripping or oozing plastic on other parts of the model.
Wipe Tower is used when changing extruders.
The active nozzle creates a tower of the specified size
and will use it to wipe the nozzle in order to reduce the
possibility of oozing or dripping material on the model while the other extruder is active.
The last page on the Print
tab is called Advanced.
The Advance page currently
only has the Extrusion Width
section.
The First Layer parameter allows you to specify the extrusion width of the first layer. A first
layer width that's larger can help with how the material adheres to the bed. You can specify it as either
an actual width, or as a percentage of the normal extrusion with (typically the same as the nozzle
diameter).
Support Material allows you to specify how wide you want the extrusion to be for the support
structure if you're using it.
Rostock MAX v2 Assembly Guide
293