SeeMeCNC Rostock MAX v2 Assembly Manual page 239

G1 Y90 Z0
G4 S5
G1 X0 Y0 Z0
If you're reading this as a PDF, you can easily copy & paste the G-Code into the editor window.
Click the Save button to save the new macro.
When you're done, click the Close button on the Macro Editor. The CONTROLS screen
should now have a macro display that looks like the figure below.
The
macro is a
button you
Fig. 19-32: Available macros.
can click
on. DO NOT CLICK IT YET.
In order to make the calibration as accurate as possible, you'll need to bring both the heated bed
and the hot end to operating temperature. The simplest way to do that is to click the "ABS" buttons as
shown:
When
you
click
on the
button,
it will
Fig. 19-33: Preheating the bed & hot end.
execute the script you just entered. The script will move the nozzle to 0.2mm above the center of the
build plate and pause for five seconds. It will then move to the X tower, then the Y tower, then the Z
Rostock MAX v2 Assembly Guide
239