SeeMeCNC Rostock MAX v2 Assembly Manual page 280

The EEPROM Settings configuration option will allow you to edit firmware parameters that are
stored on the controller inside your Orion. Please take special care when changing EEPROM values.
An improperly set configuration parameter can cause your Orion to misbehave. Sometimes rather
dramatically. :)
Here's an example of the things you can change under the EEPROM Settings configuration:
The
Gcode
Fig. 24-4: Accessing the GCode terminal.
Terminal is where you can directly interact with the firmware on your Rostock MAX.
When you first open the Gcode Terminal, you'll be presented with a window that looks similar
to the one below:
Fig. 24-6: GCode Terminal Window.
Rostock MAX v2 Assembly Guide
Fig. 24-3: EEPROM Table Editor.
280