SeeMeCNC Rostock MAX v2 Assembly Manual page 274

them up into your print queue.
To load a file into MatterControl, make sure you're on the Print Queue page and click the Add
button at the bottom right hand corner of the window.
Navigate to where you've stored the STL or ZIP file and open it using the Open File dialog that
will appear.
Once you have the object loaded, click on the Advanced Controls button so we can make sure
your print settings are the way you want them.
For my print, I've decided to leave the QUALITY setting at Coarse and I'm using the tweaked
material values that I set up earlier.
Because the key chain is pretty large, I'm going to scale it down to 75% of it's original size.
This is an easy task in MatterControl.
Rostock MAX v2 Assembly Guide
Fig. 23-1: Adding an object to the print queue.
274