SeeMeCNC Rostock MAX v2 Assembly Manual page 155

Next, slide the hot end ring spacer over the
hot end.
Fig. 11-23: Spacer installed.
Now flip the hot end over and press the wiring into the
strain relief notch in the hot end mounting plate as shown.
Fig. 11-25: Strain relief notch.
Rostock MAX v2 Assembly Guide
Fig. 11-22: Hot end mounting plate.
Now fix the hot end in place by re-installing the
large retaining nut and tightening it.
wire tie. Insert the wire tie through the slot
highlighted in green in Fig. 11-25.
Fig. 11-26: Hot end wires tied into place.
Fig. 11-24: Nut attached.
Bind the hot end wires into place using a
155