Installing & Connecting The Rambo Controller; Preparing The Rambo Mounting Plate - SeeMeCNC Rostock MAX v2 Assembly Manual

16 – Installing & Connecting the RAMBo Controller

Preparing the RAMBo Mounting Plate

For this task, you're going to need the following materials:
You'll also need two short wire ties in order to attach the fan to the back of the RAMBo
mounting plate.
Let's get the 40MM fan attached. Lay the mounting plate on your work surface so that the
opening for the fan is on the left edge. Set the 40MM fan over the opening with the blades facing you.
Fig. 16-1: Mount & fan orientation.
Fig. 16-3: Wire tie closed.
Rostock MAX v2 Assembly Guide
First, attach the lower left corner as shown. Try not
to capture the power wires when you close the wire
tie. :)
Fig. 16-2: First wire tie location.
Install the second wire tie in the upper right mounting hole
Fix the fan in place with two wire ties.
182