SeeMeCNC Rostock MAX v2 Assembly Manual page 48

The power supply base is held in place with the vertical supports that are installed to either side
of it. You'll install all three parts at the same time – the fit tolerance is loose enough that they just drop
in. Make sure that when you're installing the vertical supports that the 1/2" screws you installed are
facing inward. These screws are used to capture the acrylic covers that are installed later.
Fig. 4-18: Vertical support & power supply installation.
Fig. 4-19: Right side view of the
installation.
Rostock MAX v2 Assembly Guide
Fig. 4-20: Right side fully seated.
48