SeeMeCNC Rostock MAX v2 Assembly Manual page 37

Before we add the RAMBo connector to the wires we just cut free of the power supply, now
would be a good time to neaten up the remaining wiring that won't be used. Using a regular wire tie
(you'll need to supply this!) bundle up the unused wiring and then use another to bind the bundle to the
power supply as shown below.
Fig. 3-20: Routing the wire tie through a vent.
Now you'll need to locate the RAMBo power connector – this is a six position compression
terminal block and will be found in the little zip lock baggie that's in the RAMBo box.
Rostock MAX v2 Assembly Guide
Fig. 3-22: RAMBo power connector.
Fig. 3-21: All done!
37