Smoke Test - SeeMeCNC Rostock MAX v2 Assembly Manual

Carefully set the Borosilicate glass plate on top of the Onyx and rotate it so that the mark you
put on the glass edge aligns with the center screw next to the bed heat LED as shown below.
Fig. 17-19: Glass alignment.
Now scare up the six document clips that were included in the kit and install them as shown.
(I bet the guy that invented those things is constantly amazed at their non-document uses!)

Smoke Test!

One last thing (there's always something else, isn't there?) you should do is a final check of all
Rostock MAX v2 Assembly Guide
Fig. 17-20: Document clips installed.
208