SeeMeCNC Rostock MAX v2 Assembly Manual page 265

Here's what you end up with after removing the support material from your part. As you can
see, there's still a little clean up to to be done to the printed cube (on the left). A quick hit with some
220 grit sandpaper will knock the rough edges of the support material down.
Fig. 22-8:Part cleanup.
Simple settings level. Next, let's dig into the Intermediate setting!
Click on the Simple setting drop down and pick Intermediate. Your MatterControl settings
screen should change to something resembling the image below.
Rostock MAX v2 Assembly Guide
That's
pretty
much
all
there
is to
the
265