Subscribe to Our Youtube Channel
Related Manuals for SeeMeCNC Rostock Max v3
Summary of Contents for SeeMeCNC Rostock Max v3
- Page 1 Rostock Max v3 RTP User Guide SeeMeCNC Guides Rostock Max v3 RTP User Guide Give a short summary. Written By: JJ Johnson © 2017 seemecnc.dozuki.com Page 1 of 11...
- Page 2 Your machine was fully assembled, calibrated and printed successfully before it left our factory. Please make sure there are no damages to your new Rostock Max v3. Inspect it carefully for any broken parts. If you find any damages please STOP and contact the company that you purchased it from immediately.
-
Page 3: Step 1 - Read Me First
Rostock Max v3 RTP User Guide Step 1 — READ ME FIRST! Please thoroughly read the Introduction - Read Me First Want to download this guide as a PDF? Click on the PDF link just above the image and save as ... - Page 4 Rostock Max v3 RTP User Guide Step 2 — Remove the Shrink Wrap Remove the printer from the shipping container if you have not done so already. You can do this by lifting the printer straight up out of the container.
- Page 5 Rostock Max v3 RTP User Guide Step 4 — Remove the Glass Build Plate Rotate the [BLUE] bed clamps to remove the glass build plate and accessories from the printer. Remove the glass plate from the printer. Step 5 — Remove Accessories from Glass Plate Carefully remove all shrink wrap from the glass build plate.
- Page 6 Rostock Max v3 RTP User Guide Step 6 — Identify the Accessories Attached to the glass plate was a bag of accessroies. They are shown here. Each printer comes with a power cable, USB cable, glue stick (for prepping glass plate) and SD card.
- Page 7 Rostock Max v3 RTP User Guide Step 8 — Installing the Spool Holder Position the spool holder on the top plate of the machine in the four rectangular cutouts. Slide the spool holder assembly towards the outer edge of the printer, locking it in place.
- Page 8 Rostock Max v3 RTP User Guide Step 10 — USB Connection (Advanced) The Rostock Max v3 is equipped with a USB connection and cable. This is intended to be used as a connection for updating firmware and manually control the machine when diagnosing issues is required.
- Page 9 Rostock Max v3 RTP User Guide Step 11 — Loading Filament The spool of filament should be installed on the printer so the filament is coming off of the top side and down to the extruder as shown. ...
- Page 10 Rostock Max v3 RTP User Guide Step 12 — Software and Setup To operate your Rostock Max v3 software is required to prepare printing files. We recommend and support using MatterControl. Download and install MatterControl per your operating system Windows ...
- Page 11 Rostock Max v3 RTP User Guide Step 14 — Using MatterControl / First Print Your next step is to download and check out the MatterControl User Manual It will guide you through setting up MatterControl and running your first print!
Need help?
Do you have a question about the Rostock Max v3 and is the answer not in the manual?
Questions and answers