SeeMeCNC Rostock MAX v2 Assembly Manual page 174

Install the top by aligning it as shown below and fitting the tabs from the three vertical supports
into the slots in the top. Work your way around the perimeter, doing a bit at a time until it's fully
seated.
Fig. 14-12: Top set in place...
Congrats! There's one last step to take before the mechanical build of your Rostock MAX v2
3D printer is completed!
That's right, you need to install the spool holder IN the mount! Now pay close attention, this is
brutally complex.
First, put your arms together. No, not YOUR arms, ^^^^ those arms. Jeez.
Rostock MAX v2 Assembly Guide
Fig. 14-14: Arms together now!
Now you need to install one #10-32
nylon thumbscrew in the hole at each
"corner" of the top in order to lock it into
place.
Fig. 14-13: Thumbscrews installed.
174