Working With The Lamp; Turning The Lamp On/Off; If The Lamp Won't Turn On - Christie CP2000-SB User Manual

3.8

Working with the Lamp

Simple software controls and adjustments can help to optimize lamp performance and ensure the brightest,
most uniform image possible for the life of the lamp. These controls are located in the Main, Advanced:
Preferences, and Advanced: Lamp menus on the TPC.
NOTE: For individual menu functions, refer to

3.8.1 Turning the Lamp ON/OFF

ON
With all CP breakers set to ON, ignite the lamp by pressing the lamp button on the Main menu of the TPC-
make sure to press and hold for approximately ½ second.
OFF
To turn the lamp OFF, press the lamp button on the Main menu of the TPC-make sure to press and hold for
approximately ½ second. Then WAIT for fans to run for 10 minutes to cool the lamp and other compo-
nents then turn off all breakers.

3.8.2 If the Lamp Won't Turn ON

If the lamp fails to ignite, the projector will automatically re-try ignition using 100% of the maximum power
acceptable for the lamp. If this re-try also fails, and there is no interlock problem such as an open lamp door, a
new lamp is likely needed.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Section 3.5 Using the Touch Panel Controller
Figure 3-45 Lamp Button on TPC
Section 1: Introduction
(TPC).
Lamp ON/OFF -
Select and hold
for 1/2 second.
3-57