Input Settings; No-Signal Input Monitoring - IDK MSD-702UHD User Manual

9.6

Input settings

9.6.1 No-signal input monitoring

Menu Top→INPUT SETTING→INPUT VIDEO DETECT
Setting for Each input channel (only digital input signal)
Setting value OFF, 2000ms to 15000ms (100 ms steps) [Default] 10000ms
If you change the EDID settings of the MSD or power the MSD off/on, the source device may not output a
video signal. Use this menu to set the monitoring time which is from when a source device stops outputting
signal to when the MSD requests the source device to output video signal.
Changing EDID
ON
Video signals from
source device
OFF
Monitoring time
ON
Hot plug
OFF
[Fig. 9.9] Monitoring absence of input
Note:
If you are using the monitor power-saving or dual monitor features on your PC, set this feature to "OFF". This
will avoid unpredictable operation.
When using this feature, ensure that the "monitoring time" is set for a value greater than the amount of time
needed for the source to provide an output signal.
MSD-701UHD / 702UHD / 801UHD/ 802UHD User's Guide
Requesting source device to
output video signals
Video signals from
source device
Requesting source device to output video signals
Changing EDID
Monitoring
Monitoring
time
time
ON
OFF
Video output timing of source device
[Fig. 9.10] Repeating reset
Monitoring
time
57