Table of Contents
Advertisement
3.3.9 EDID
@GED / @SED
Getting
Command
Response
Setting
Command
Response
Parameter
Getting
Command
example
Response
Description Getting the set EDID.
Setting
Command
example
Response
Description Setting IN2: EDID that is read from the sink device connected to OUT3.
Remarks
MSD-701UHD / 702UHD / 801UHD/ 802UHD Command Guide
EDID
@GED
@GED, edid_1, edid_2, edid_3, edid_4, edid_5, edid_6, edid_7, edid_8
@SED, ch_1, edid_1 (, ch_2, edid_2･･･)
@SED, ch_1, edid_1 (, ch_2, edid_2･･･)
edid_1-8: EDID
0 = Built-in EDID [Default],
1 = OUT1A MONITOR,
2 = OUT1B MONITOR,
3 = OUT2A MONITOR,
4 = OUT2B MONITOR,
101 to 108 = COPY DATA 1 to COPY DATA 8
ch_1-8: Input channel
0 = All digital inputs, 1 = IN1 to 8 = IN8
@GED
@GED,0,0,0,3,0,0,0,0
IN4: EDID of the sink device that is connected to OUT3,
other inputs: built-in EDID
@SED,2,3
@SED,2,3
These commands are only for digital input.
IN6 and IN7: If "0" (Analog signal) is selected for "@GIN / @SIN Signal selection
of DVI input connector", "-1" is acquired and the setting cannot be valid.
In order to use a copied data, read EDID data from the sink device in "@RME
Copying EDID" in advance.
67
Advertisement
Table of Contents
