Copying Edid - IDK MSD-501 User Manual

MSD-501/502/701/702 User's Guide
You can set the speaker configuration of multi channel audio.
This menu is valid only if you select "INTERNAL EDID" for "7.10.1 EDID", you select a resolution other than
"UNUSED" for "7.10.3 Input resolution for AV devices".
If you select "AUTO" for the setting mode and set the number of speakers, the speaker configuration will be
set to the default setting that is shown in the following table. To change the default configuration, set the mode
to "MANUAL" and set each speaker to ON/OFF individually. If the number of speakers exceeds the available
value, the "DATA INVALID" message is displayed and the settings will not be applied.
The setting of this menu is not updated until the MENU/SET key is pressed. Make sure to press the
MENU/SET key to update the setting.

7.10.7 Copying EDID

Menu Top→EDID→MONITOR EDID COPY
Setting value OUT1A, OUT1B, OUT2A, OUT2B
EDID of the sink device is loaded and registered to the MSD.
Up to eight EDID can be registered.
To register an EDID, press the "MENU/SET" key.
65