Advertisement
t
2
3
Talk with the other party
Press f when you finish the call
4
･
To end the videophone call by closing FOMA terminal, change the setting in Close Setting.
INFORMATION
You can also make a videophone call by performing in order of Steps 2, Step 1. When t is pressed and the phone
●
number is entered, a videophone call is made automatically after about 5 seconds.
You can make videophone calls by attaching Chaku-moji. ☛P55
●
You can make videophone calls by setting conditions. ☛P58
●
When Speakerphone is set to ON in Videophone Settings and Silent Mode is active, if you make a videophone call, a
●
confirmation screen appears asking whether to switch to the speakerphone call. Select Yes or No.
If a videophone call cannot be made, one of the following message is displayed on the screen and then the standby
●
display returns. Note that the displayed message may not reflect the status of the other party's terminal correctly,
depending on the type of the terminal and/or the network service used by the other party.
Message
Check number, then redial.
Busy.
Out of service area/power off.
Set Caller ID to ON.
Redial using voice call.
Busy with packet transmission. The other party is in packet communication.
Connection failed.
*1 The message may also appear when the other party is in packet communication, depending on his/her terminal.
*2 As of May 2006, the message may also appear when the other party has activated Voice Mail Service.
Your image is displayed while being connected.
･
If the phone of the other party is busy, you will hear a busy signal. The
message, Busy. or Connection failed. is displayed on the screen. Press f to
end the call and call again later. You can call back quickly by using Redial.
Pressing t while being connected sends the substitute image set in Image
･
Setting. When the substitute image is set to Chara-den, Chara-den may not be
displayed. If this happens, the default image for the substitute image setting is
sent to the other party. ☛P92
･
Charging begins when Connected to videophone. is displayed.
The other party's voice comes out of the speaker (Speakerphone function).
To put the call on hold: o
･
To turn on/off the speakerphone function: a or n
･
･
Depending on the other party's settings, the substitute image may be
displayed.
･
To disable turning on the speakerphone function automatically, change the
setting in Videophone Settings.
You dialed the phone number not used.
1
The other party is busy.*
The other party is outside the service area or the other party's terminal is turned off.
This message is displayed in case connecting without notifying the caller ID (when
accessing to V-Live or visualnet).
This message is displayed when the other party sets Call Forwarding Service and the
forwarding destination is the terminal which is not compatible with videophone.*
Set Caller ID Notification to Notify and dial again.
･
The message may appear in cases other than the above.
Description
2
Next
81
Advertisement
Chapters
