Advertisement
Enabling use of a sub address
Default ON
m8674
1
Press 1
2
To cancel the setting: 2
･
Making a call by specifying a sub-address
1
Enter the phone number
Press n (for voice call) or t (for videophone call)
2
･
The sub-address needs to be set on the other party's phone or communication device.
INFORMATION
Even when Sub Address is ON, if "
●
sub-address delimiter and sent as tone signals (DTMF) containing "
Setting the alarm indicating reconnection of interrupted call
Set an alarm that is heard at the time of reconnecting a voice call, videophone call or PushTalk call
interrupted due to poor signal conditions in a tunnel or behind a building when signal conditions improve.
･
The other party hears no sound while signals are disrupted.
･
The time until the call is reconnected depends on line use or signal conditions. (The approximate time is a
maximum of 10 seconds.)
･
Note that the call is charged for the time until the call is reconnected (up to 10 seconds).
･
The call may be cut off before the alarm sounds depending on line use or signal conditions.
Default High alarm
m81164
1
Suppressing ambient noises to improve the call quality
By suppressing ambient noises during a call, the other party can hear your voice clearly and you can
also hear the other party's voice clearly.
･
It is recommended that this function usually be set to ON.
Default ON
m8681
1
Press 1
2
To cancel the setting: 2
･
z
(
z
Enter the sub-address
" is entered after entering a pause, timed pause or "#", it is not recognized as a
z
Press any of 1 to 3
".
Reconnect Alarm
Noise Reduction
61
Advertisement
Chapters
