Advertisement
Mail data received from the device that can save mail by
●
the folder may be saved in the Message i-
To check the saved mail data, select the Message i-
folder in which the data is saved and press m1.
Activating infrared communication mode
Infrared Communication Mode
Activate i-
ppli by receiving the data to start
α
i-
ppli via infrared communication device having
α
the function of starting i-
･
It is necessary to download the specified software
from sites, etc. beforehand.
･
In case i-
ppli is set not to start with the i-
α
To function via an external device, i-
be activated.
m62212
1
Receiving standby condition is activated.
2
Receive the data to start i-
infrared communication device
i-
ppli is activated.
α
To cancel receiving data: o
･
Using the infrared remote control
function
FOMA terminal can be used as an infrared
remote controller by downloading the i-
infrared remote control.
･
Download the i-
ppli suited for the individual
α
device.
･
If the preset i-
ppli Gガイド番組表リモコン
α
(G-GUIDE TV Remote Controller) is activated,
FOMA terminal can be used as an infrared
remote controller for TV, etc. ☛P279
･
This function is unavailable during Self Mode is
on or infrared communication is executed.
･
Communication may be influenced by the model
of the supported device used and ambient
luminance.
･
Some equipment cannot be operated even if it is
compatible with infrared remote control.
ppli folder.
α
ppli
α
ppli.
α
ppli
α
ppli cannot
α
z
Select Yes
ppli via
α
ppli for
α
Remote control operation
Perform remote control operation with the infrared
data port of FOMA terminal pointed at the infrared
receiver of the supported device used (operating
procedure differs depending on i-
remote control is 15 degrees from the center and the
distance is approximately 4 m at the maximum.
However, the angle and distance allowed for the
operation differs depending on the type of devices to
operate and the level of brightness in the environment.
Infrared receiver
Approx. 4 m
15°
15°
Infrared data port
Setting operations for data transfer
Set operations for data transfer by infrared
communication and USB connection.
Default End alert: OFF Auto Authentication: OFF
Ph. book image sending: ON
m623
1
2
Select each item to set
End alert：
Specifies whether to sound a
communication end tone at the end of
communication.
Auto Authentication：
Specifies whether to automatically exchange
authentication codes with the other party
while connecting to USB.
･
To set ON, enter the terminal security code
and the 4 to 8-digit authentication codes
for a mobile phone terminal (FOMA
terminal)) and for PC (the other party), and
then press p.
Ph. book image sending：
Specifies whether to send images saved in
the phonebook along with the all phonebook
data when sending all data items.
Press p
3
ppli). Angle for
α
Data Transfer Setting
351
Advertisement
Chapters
