Advertisement
Flow of setup for data communication
The setup work needed to connect FOMA
terminal to a PC to perform packet or 64K data
communication is as follows:
Install the communication configuration file
Connect a PC to FOMA terminal
Check the communication configuration file
Install the FOMA PC configuration software
(Easy Setup)
Packet communication
setup
Execute communication
Set up communications without using FOMA PC
configuration software
Connect
Communication configuration file (driver)
Install the communication configuration file on a PC
from the attached CD-ROM, before connecting
FOMA terminal to a PC to perform packet or 64K
data communication.
FOMA PC configuration software
When the FOMA PC configuration software (found on
the CD-ROM) is installed on a PC, a number of
settings required for data communication via
connection between FOMA terminal and PC can be
made from the PC by simple operation.
402
(Easy Setup)
64K data communication
setup
Checking operating environment
Use the communication configuration file and the
FOMA PC configuration software in the following
operating environments:
Item
PC *
1
PC/AT compatible computer
OS
The Japanese version of
Windows 98, Me, 2000 or XP
Windows 98, Me: 32MB or more
Memory
Windows 2000: 64MB or more
requirements
Windows XP: 128MB or more
Hard disk capacity
5 MB or more free disk space
*1 USB port (conform to USB specification 1.1/2.0) is
required.
INFORMATION
Note that utilization may not be possible in certain
●
operating environments. Furthermore, operation will not
be guaranteed in an environment other than that
described above or by upgrading the OS and DoCoMo
assumes no responsibility for operation under such
conditions.
AT command
AT commands are commands for setting FOMA
terminal functions using a PC.
FOMA terminals comply with AT commands and
support some extended commands and
proprietary AT commands.
For details of AT command, see "Manual for Data
Communication" in CD-ROM provided.
Requirements
Advertisement
Chapters
