Advertisement
Trial channel
Basic channels are available for free of service
charge for a set period of time to i-mode subscribers
who use an i-channel compatible terminal, and who
have never signed up for the subscriber line.
However, packet communication fee caused by
viewing detail information from the channel list is to
be borne by the users.
･
For important notes on using Trial channel and
detail information about how to use the service, see
"i-mode User's Manual".
In principle, Trail channel automatically begins after a
set amount of time once the UIM (FOMA card) is
inserted and the i-channel compatible terminal goes
into use. If Trial channel does not start automatically,
you can start it by pressing c.
Trial channel is available only once per subscriber
line.
Trial channel automatically stops after a certain
period of time following the launch. For information
about how to stop the channel, see "i-mode User's
Manual".
INFORMATION
Neither ring tone nor vibrator operates at the reception of
●
information. Likewise, the Enter key does not light or
flash.
If you cancel i-channel or i-mode service subscription,
●
tickers are no longer displayed. Pressing c displays
the pre-subscription screen. Until the cancellation
procedure has finished, however, tickers may be
displayed on the screen and pressing c may display
the last received information in the channel list.
When Show ticker is set to No in Ticker Setting, no tickers
●
are displayed.
If you cannot receive information because FOMA
●
terminal is turned off or due to out-of-service area or poor
signal quality, press c to receive information.
blinks during reception of information.
●
Changing the i-channel host
You can change the i-channel host (although you
usually do not need to change it).
a d88
b Highlight the user host
terminal security code
c Select each item to set
･
Host address2 should be filled with the address
of the i-channel host (up to 30 one-byte
characters).
Host address is the host for i-mode. ☛P212
･
d Select the host you have edited
● If you enter or change the address of Host
address2, the i-channel information will no longer
be displayed on the standby ticker. Sometimes,
the information will not be updated
automatically. When you press c on the
standby display to view the channel list, the
latest information is received and the tickers are
shown on the standby display.
Displaying i-channel
c
1
The channel list appears.
･
When video/i-motion, Chara-den or i-
set as the standby display: d71
i-channel cannot be displayed even if c
･
is pressed.
2
Select the channel
Your terminal connects to the site and the
information appears.
･
Depending on the situation, information may be
received when displaying the channel list.
INFORMATION
To refresh the channel list, press m in the channel list
●
and select Retry.
When you press m in the channel list and select Sound
●
effect setting, you can set whether to enable sound effect
for Flash movie. For setting ☛P213 "Setting image
display and sound effects"
z
m
z
Enter your
z
p
z
p
Menu 271
Channel List
ppli is
α
291
Advertisement
Chapters
