Advertisement
Any incoming videophone call cannot be answered
●
during download. Unanswered calls are recorded as
missed ones in the received call history.
Even if an alarm clock or any alarm is set while software
●
is being updated, the updating continues without
activating the alarm clock or the alarm.
For software update, SSL session is established to the
●
server (our site). Enable SSL certificate in Certificate
Setting. Configured as valid by default. ☛P217
Software update should be done with battery fully
●
charged and enough battery power (
It is recommended that software update be executed
●
when good signal quality is obtained, 3 bars of the
antenna icon (
) are displayed and the terminal is not
being moved.
･
If radio wave signals become weaker during software
downloading or downloading has stopped, retry
software update in a place with strong radio wave
signals.
A displayed icon for the message stored at i-mode
●
Center disappears after software update.
If Receive Option Setting is set to ON and mail arrives
during software updating, the screen that notifies an
arrival of mail in the i-mode Center may not appear after
the software update being completed.
Never remove the battery pack while updating software.
●
Update fails.
Software update can be done while various data, such as
●
the phonebook/PushTalk phonebook entries registered
in FOMA Terminal, camera images, downloaded data
are retained; however, note that data protection
sometimes cannot be secured depending on the
conditions of your FOMA terminal (such as malfunction,
damage, or water leak). DoCoMo recommends backing
up necessary data. (Note that some data such as
downloaded data may not be backed up.)
When software update has failed, the message Rewrite
●
failed appears and all the operations are unavailable. In
such a case, please bring FOMA terminal to a repair
office designated by DoCoMo.
In case updating is not required, when checking the
●
necessity of software update, a message is displayed
indicating update is not necessary, so use as it is.
Software update is available even if Host Selection is set
●
to other than i-mode.
Starting software update
m886
1
2
Enter the terminal security code
notice and o
458
).
･
･
o o
3
update is required
･
■
z
Check
The entered terminal security code (4 to 8
＊
digits) is displayed as "
".
The terminal security code by default is set to
"0000".
z
Confirm whether software
Pressing o on the confirmation screen for
sending terminal ID makes connection to the
server and your private information concerning
the mobile phone (such as model, serial
number) is sent.
When updating is not necessary:
If software updating has
been found to be
unnecessary as a result
of checking for the
necessity of updating,
the screen as shown on
the left is displayed.
Press o to use FOMA
terminal as it is.
Advertisement
Chapters
