Advertisement
Setting the date and time
The time setting can be performed in 2 ways: obtaining the time information from DoCoMo network to
adjust the time setting of FOMA terminal, or manually entering the current time to the terminal.
Default Auto time adjust: ON Offset: +, 00h00m
m851
1
2
Select each item to set
Auto time adjust ：Set whether to perform the automatic time correction.
･
：Specify the amount of time advance (+) or delay (-) so that your terminal's clock
Offset
advances from/delays to the time obtained for a given length of time.
･
･
：Set the date and time.
Date, Time
･
･
･
The entered numbers can also be increased or decreased with %. Also, highlight the number with &
･
to change to enter it.
Press p
3
When the automatic time correction is set
The automatic time correction takes place when the UIM is inserted and you turn the power on in a location
where radio waves reach.
･
The automatic time correction sometimes causes a time error of several seconds. In addition, it may fail to
correct the time depending on the radio wave condition.
･
If the time information is received while i-
･
When Auto time adjust is set to ON, the time may not be corrected for a while. To enable the automatic time
correction, turn the power off and then on.
･
When no UIM is inserted or FOMA terminal is out of the service area, the automatic time correction is not
performed even if you turn the power off and then on.
INFORMATION
You cannot use the following functions when the date and time are not set:
●
･
Auto Power ON/OFF
ppli auto start ☛P282
･
i-
α
･
Scheduler (including data transfer and display of data on the miniSD memory card)
･
Downloading and playing i-motion with replay restrictions set ☛P321
･
Software Update
･
Random Display Image (when Chang image is set to other than Open slide or Speed selector)
If the date and time are not set, the date and time are not recorded for the following functions and "----/--/--" or
●
"----------------" is displayed. A number to segmentalize (segmental number) may be appended.
･
When you set Auto time adjust to ON, Offset can be set. Date and Time cannot
be set.
To enter the date and time manually, set Auto time adjust to OFF.
Enter the time between 00h00m and 23h59m.
Prefix 0 if the hour and/or minute is a single digit (0 to 9).
Enter the year by the last 2 digits of the year. From January 1, 2000 to December 31,
2050 can be set.
Enter the time in the 24-hour clock (00h00m to 23h59m).
Prefix 0 if the month, date, hour and/or minute is a single digit (0 to 9).
ppli is running, the time may not be corrected depending on the i-
α
･
Alarm Clock
ppli DX ☛P270
･
i-
α
･
Update Definition
･
Certificate Download ☛P217
･
Flash movie which uses the date and time setting
･
SSL communication (authentication)
Date and Time Setting
ppli.
α
Next
47
Advertisement
Chapters
