Preventing Use Of Ic Card Functions; Ic Card Lock - Foma D902iS Manual

Preventing use of IC card functions

IC Card Lock disables use of the IC card by
holding the FeliCa mark over a reader/writer. It
also disables acquisition of ToruCa and download
of Osaifu-Keitai compatible i-
･
The setting is retained even if the power is turned
off.
･
IC Card Lock cannot be set when All Lock is
active. To set both IC Card Lock and All Lock, first
set IC Card Lock and then set All Lock.
･
Setting Omakase Lock (Remote Lock)
automatically sets IC Card Lock. However, icon
for showing that IC Card Lock is on is not
displayed.
Default OFF
r (for over a second)
1
IC Card Lock is set and
standby display.
Canceling
･
+
When Voice SecurityCode is set as the procedure
for canceling IC Card Lock, and voice keyword for
authentication is recorded, voiceprint
authentication is needed for canceling IC Card
Lock.
･
For voiceprint authentication, please take the
following precautions:
･
Hold the terminal in the same way as when you
are recording. (In the same way as you speak
over the phone, hold the terminal beside your
face, or 5cm away from the front of your face.)
･
A voice is hard to be recognized in the cases
that circumference is noisy.
･
A voice is hard to be recognized when using the
flat type earphone/microphone set with
switch(optional), etc.
r (for over a second)
1
After about 2 seconds, a beep is heard and
recording starts.
･
When Security code is set for the procedure to
cancel IC Card Lock, go to Step 3.
2 Say the authentication keyword within 5
seconds
When the keyword is authenticated, the terminal
security code entry screen appears.
To stop the authentication: o
･
300
Menu 642 / Menu 83131

IC Card Lock

ppli.
α
z
Select Yes
appears on the
･
When there is a noise around, Please try again
to verify voiceprint in quiet place. is displayed.
Press o and say the keyword again.
･
If the keyword was not authenticated, the
message appears. Press o and say the
keyword again.
Pressing C for over a second, without
･
voiceprint authentication operation, displays
the terminal security code entry screen.
3 Enter the terminal security code
INFORMATION
You can also set/cancel in shortcut operations.
●
m642 or m83131
the terminal security code
･
+
When Voice SecurityCode is set as the procedure for
canceling IC Card Lock, voiceprint authentication is
needed before entering the terminal security code.
Depending on words you registered or conditions where
●
you recorded, voiced data may be certified by the
neighboring sounds or the similar words. It may happen
easily, when you registered a particularly short word or
recorded at a noisy place.
When you fail voiceprint authentication 5 times
●
consecutively, the voiceprint authentication stops.
Enabling to cancel by voice and the terminal
security code
Set the authentication operation that is necessary for
canceling IC Card Lock
･
Only one voice recording for about 0.5 to 2 seconds
can be made.
･
Please take the following precautions when
recording:
･
Record at as quiet a place as possible with little
neighboring noise.
･
It is recommended to register words of 5 to 10
syllables. In addition, please avoid the words
that you do not usually use, because
pronunciation does not maintain the same.
･
Say the keyword
which was set in IC
Card Lock Setting.
z
Enter
z 1 or 2
Menu 83133
IC Card Lock Setting