Advertisement
Inserting the card
Removing the card
aPull out the UIM slot tray.
･
The operations are the same as a to b in
"Inserting the card".
bRemove the UIM by sliding it out.
INFORMATION
Insert or remove the UIM carefully as forcing it may damage the card.
●
Carefully handle the removed UIM so that it does not become lost.
●
When attaching the battery pack, make sure that the UIM slot is in place. If not, you cannot attach the battery pack.
●
Forcibly attaching the battery pack may damage the UIM or the UIM slot.
When pushing the UIM slot in, make sure that the UIM is properly placed in the slot and the lid is flat. Forcibly pushing
●
the slot into FOMA terminal may cause an operation error.
UIM security codes
The PIN1 and PIN2 codes are used for the UIM.
Both codes are set to "0000" at the time of subscription to the FOMA service. You can change this to any code
(4 to 8 digits). ☛P156
UIM operation restriction function
FOMA terminal is provided with the UIM operation restriction function for protecting your data and files.
･
When the data or files downloaded from sites or the data attached to mail are saved in FOMA terminal with
the UIM inserted, the UIM operation restriction function is automatically set to these data or files.
Tray is pulled out until it stops.
Slot tray
Cut corner
UIM slot cover
Cut corner
IC
UIM
aRemove the rear cover and then
the battery pack. ☛P41
bPull out the UIM slot tray.
Place your finger on the slot cover
and slide it out until the slot tray
stops.
cInsert the UIM into the slot with
the IC side of the card facing
down.
dLift the slot cover until its bottom
is even with the slot tray.
Align the cut corner of the slot tray
to the cut corner of the UIM.
ePush the slot tray in until it
stops.
fReattach the battery pack and
then the rear cover. ☛P41
When the UIM slot tray is removed
Insert the UIM slot tray
and push the tray straight
in.
● Remove the UIM
before replacing the
slot tray.
Next
39
Advertisement
Chapters
