Advertisement
Turning the power on
Hold down f for over 2 seconds
1
The wake-up screen appears and then the standby display is displayed. Displaying the wake-up screen
may take some time.
Battery level icon
is indicated while reading the UIM and
disappears when reading is completed.
Turning the power off
Hold down f for over 2 seconds
1
INFORMATION
When you turn on the power of FOMA terminal after replacing the UIM (except when Omakase Lock (Remote Lock) is set),
●
entry of the 4 to 8-digit terminal security code is required. After entering the correct PIN1 code, the standby display appears. If
a wrong terminal security code is entered 5 times consecutively, the power is turned off (can be turned on again).
Calls may be cut off even when
●
When PIN1 Code ON/OFF is set to ON, entry of the PIN1 code is required.
●
When Reset Call Cost is set to ON, entry of the PIN2 code is required.
●
When Normal use of Display light time in Display Light Setting is set to other than Always, if you do not press any keys for
●
about 90 seconds, the display disappears. This also applies during a voice call. If there is any key operation*
rotating the Speed Selector) or an incoming call, the display appears again.
･
The display does not disappear in following cases: during a videophone call, when the shooting screen of Camera/
Movie Camera is displayed, while shooting, while charging with AC adapter connected of Display light time set to Always
on, or while executing the function for which Display light time is set to Always on.
*1 Pressing dial keys does not enter numbers, except during a call.
Switching to English display
Default Japanese
m8272
1
Press 2
2
To switch to Japanese display: 1
･
INFORMATION
The setting is saved in the UIM.
●
Note: The miniSD memory card is not included in the bundle and needs to be purchased. ☛P331
46
Icon
Received
Received
signal level
signal level
･
If the date and time have not been set, a message indicating that
is displayed. When FOMA terminal receives the time information
Date/day/time
and the time is automatically corrected, the message disappears.
Press o to set the date and time manually.
･
If no UIM is inserted, a message indicating that insertion of the
The standby
UIM is required is displayed. Turn the power off, insert the
image is
UIM and then turn the power back on.
displayed.
･
The following items can be changed:
Standby image ☛P136
・
Time display format ☛P151
・
is indicated and you are not moving.
Strong
Weak Outside the service area
and where radio waves
are hard to reach
Battery level icon ☛P147
・
1
(except
Select Language
Advertisement
Chapters
