Advertisement
Checking the miniSD memory card
You can check the data saved in the miniSD memory
card and restore it if there is any problem.
･
The data may not be restored depending on the
condition of the miniSD memory card.
m65
z
a
1
2
Select Yes
Using the miniSD memory card from PC
Set USB Mode Setting to miniSD mode and
connect FOMA terminal to PC with the FOMA
USB cable (optional). Then you can operate the
data of the miniSD memory card inserted in
FOMA terminal from PC.
･
OS supporting the miniSD memory card is
Windows XP and 2000 only.
･
Connect FOMA terminal to PC when the power is
on.
･
In case of executing data communication by
connecting FOMA terminal to PC, set this to
Communication mode.
Default Communication mode
m624
1
2
z
2
Select Yes
To set Communication mode: 1
･
3
Connect FOMA terminal to PC
Release
button
Note: The miniSD memory card is not included in the bundle and needs to be purchased. ☛P331
342
Scan Card
USB Mode Setting
z
Select Yes
USB connector
Connector for FOMA
terminal (label facing up)
a Open the cap on the FOMA terminal's
external connection terminal
b Insert one end of the FOMA USB cable into
the FOMA terminal's external connection
terminal until it clicks
c Insert the other end of the FOMA USB
cable into the PC USB connector
■
Removing FOMA USB cable:
Press release buttons on both sides of the
connector for FOMA terminal and pull it out
even. Remove carefully as forcing it may be
the cause of damage. Pull out the connector
for PC.
INFORMATION
miniSD mode may not be set if the PC is set to start data
●
communication automatically when FOMA terminal is
connected.
miniSD mode cannot be set during a call, PushTalk, or
●
i-mode. Also, when the miniSD memory card is being
operated from a PC, the mode may not be set to
Communication mode.
During miniSD mode, communication such as phone call
●
or i-mode cannot be used.
USB Mode Setting is switched automatically to
●
Communication mode from miniSD mode in about 90
seconds after the last access to the miniSD memory card
without connecting FOMA terminal to a PC.
Click
on the PC task tray and click USB
●
装置デバイス−ドライブ(E:)
(Release safely the USB large memory device-Drive E:*
to quit operation of the miniSD memory card and remove
the FOMA USB cable.
*1 The character to be assigned to a drive varies by
the system of PC.
Never remove the FOMA USB cable during the data
●
transmission with the miniSD memory card. It can cause
the malfunction or loss of data.
If you format the miniSD memory card attached to FOMA
●
terminal from a PC, using on FOMA terminal may be
disabled. It is advisable to format the miniSD memory
card on FOMA terminal.
During miniSD mode, the Enter key flashes.
●
When pressing the key of FOMA terminal other than b
●
during miniSD mode, a confirmation screen appears
asking whether to switch to Communication mode.
Even when FOMA terminal is connected with PC, USB
●
Mode Setting can be changed.
The miniSD memory card folder structure during
●
operation from a PC. ☛P333
大容量記憶
1
を安全に取り外します
*
1
)
Advertisement
Chapters
