Optional Equipment
Hydrator
Electrical Connections
6-4
Mercury System Manual
2. Use the holes on the Hydrator mounting tabs to mark through-hole
location, and taking care not to over-penetrate, drill mounting holes
using the appropriate drill/bit setup. Use appropriate stainless steel
hardware to mount the Hydrator.
1. Attach the two 37-pin terminal boards supplied with the kit to the
corresponding 37-pin connectors on the rear of the 80i, and secure
with the supplied hardware.
2. Terminate additional harness wires to the jacket of the cable with a
small tie strap.
Note Pinout diagram shows only 24 "active" termination points.
Figure 6–3. Hydrator Electrical Pinout Diagram
▲
Thermo Fisher Scientific