Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 607

COPIER (Service mode for printer) > ADJUST (Adjustment mode) > ADJ-XY
ADJ-X-MG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJY-DF2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
■ CCD
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > CCD
W-PLT-X 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Fine adj img ratio: book mode, vert scan
To make a fine adjustment of image magnification ratio in vertical scanning direction at copyboard
reading.
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of service label.
As the value is changed by 1, the image magnification ratio is changed by 0.01 %.
+: Enlarge
-: Reduce
When replacing the Main Controller PCB/clearing the Reader -related RAM data
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-50 to 50
%
0
0.01
Adj start pstn: stream, horz scan, back
To adjust the back side image reading start position in horizontal scanning direction at stream
reading using the DADF (1-path).
When replacing the Main Controller PCB/clearing the Reader-related RAM data, enter the value
of service label.
As the value is incremented by 1, the image position is moved to the rear side by 0.1 mm.
When replacing the Main Controller PCB/clearing the Reader -related RAM data
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
After the setting value is changed, write the changed value in the service label.
-35 to 35
mm
0
0.1
Stdrd White Plt white lvl data (X) entry
To enter the white level data (X) for the Standard White Plate.
When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
Copyboard Glass, enter the value of barcode label which is affixed on the glass.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data
- When replacing the Copyboard Glass
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 9999
8271
COPIER> ADJUST> CCD> W-PLT-Y/Z
585
8. Service Mode