Table of Contents
Advertisement
COPIER (Service mode for printer) > ADJUST (Adjustment mode) > HV-TR
TR-DUP6
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
TR-DUP7
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
Sec trn indiv set clr mod/fd side: set 6
To set the color mode and feed side for setting 6.
Setting 6 is the combination condition of environment, paper type (paper weight), color mode/feed
side that are set in TR-ENV6, TR-PPR6 and TR-DUP6. When this condition is satisfied, the paper
allotted voltage adjusted in TR-VL6 is applied at the time of secondary transfer.
The left digit of the setting value represents the color mode and the right digit represents the feed
side.
When an image failure that differs on the 1st/2nd side occurs (mottled image/density loss due to
excessive transfer/toner scattering on solid image, etc.)
Enter the setting value, and then press OK key.
11 to 43
Left digit (color mode)
1: Color mode (entire paper), 2: Black mode (entire paper), 3: Color/black mode (leading edge of
paper), 4: Color/black mode (trailing edge of paper)
Right digit (feed side)
1: 1-sided, 2: Auto 2-sided, 3: Multi-purpose Tray 2-sided
11
COPIER> ADJUST> HV-TR> TR-ENV6, TR-PPR6, TR-VL6, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
Sec trn indiv set clr mod/fd side: set 7
To set the color mode and feed side for setting 7.
Setting 7 is the combination condition of environment, paper type (paper weight), color mode/feed
side that are set in TR-ENV7, TR-PPR7 and TR-DUP7. When this condition is satisfied, the paper
allotted voltage adjusted in TR-VL7 is applied at the time of secondary transfer.
The left digit of the setting value represents the color mode and the right digit represents the feed
side.
When an image failure that differs on the 1st/2nd side occurs (mottled image/density loss due to
excessive transfer/toner scattering on solid image, etc.)
Enter the setting value, and then press OK key.
11 to 43
Left digit (color mode)
1: Color mode (entire paper), 2: Black mode (entire paper), 3: Color/black mode (leading edge of
paper), 4: Color/black mode (trailing edge of paper)
Right digit (feed side)
1: 1-sided, 2: Auto 2-sided, 3: Multi-purpose Tray 2-sided
11
COPIER> ADJUST> HV-TR> TR-ENV7, TR-PPR7, TR-VL7, 2TR-OFF
Up to 16 combination patterns can be set in TR-VL1 to 16 (setting 1 to 16). When there is more
than one setting where all conditions (environment, paper type and color mode/feed side) are the
same, the setting with a smaller setting number is applied.
670
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
