Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 816

COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-MCON
VP-TXT 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
PASCL-TY 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
AST-SEL 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
PSCL-TBL 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Amount of Change per
Unit
Setting of character vectorization
To set vector conversion processing for text on scalable PDF.
In the vector conversion processing, a binary image outline is extracted in the field which is
recognized as text, and is converted into vector data.
In regular vector conversion, function approximation is not used for small text because the image
quality is not changed.
When the value is changed, function approximation processing is executed for small text, which
realizes smooth text although the image quality is changed.
Change this value when you want to prioritize smoothness in small text.
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 99
1
Set of paper type for auto gradation adj
Auto gradation adjustment is normally executed with the recommended paper specified for each
location. However, if you want to change the paper type, use this setting to change the paper type.
When executing the auto gradation adjustment using a paper other than the recommended paper
type
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Do not change the setting in the normal operation.
1 to 3
1: CS-680 (Except for USA and EU. Mainly for Japan)
2: Canon Multipurpose Paper (For USA)
3: Oce RED Label80 (For EU)
It differs according to the location.
Adj of advanced smoothing effect
To adjust the smoothing effect which is set in the advanced smoothing UI.
Set 3 if no smoothing effect is obtained even though High is set in the advanced smoothing UI.
Set 0 if too much effect is obtained even though Low is set in the advanced smoothing UI.
When image failures (jaggy, moire) occur
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 3
2
AST: Advanced Smoothing Technology
Setting of Bk-color density increase
To set whether to increase the density of Bk-color only without changing the density of Y/M/C-
color.
When 1 is set, the parameters of auto gradation adjustment (full adjustment) are adjusted so that
only the density of Bk-color is increased.
Upon user's request (to increase the density of Bk-color)
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
3) Execute auto gradation adjustment (full adjustment).
Be sure to execute auto gradation adjustment (full adjustment) after the setting is done.
0 to 1
0: Normal, 1: Only the density of Bk-color is high
It differs according to the location.
1
794
8. Service Mode